How to set up DP Fuser

If you have a Monitor for your Second PC, connect the Monitor directly to the Second PC. If you don't have a Second Monitor, it's ok, the setup can work with one Monitor.

2. Insert 2 AAA batteries into the remote control.

3. Press EDID button on the remote control.

This will apply the maximum resolution and refresh rate supported by your monitor and fuser.

DisplayPort Fuser supports:

1920x1080@60HZ
1920x1080@144HZ
1920X1080@165HZ
1920X1080@240HZ
2560x1440@144HZ
2560x1080@165HZ
3440X1440@60HZ
3440X1080@100HZ
3840X2160@60HZ

Second Monitor Settings

4. Open Display settings on your Second PC. If you don't have a Monitor for your Second PC, press Fusion button to see the image from your Second PC on your Main Monitor.

5. Select "Duplicate these displays".

6. At this point you will most likely see the image from the Second PC on your Main Monitor.

Press Fusion button on the remote control or on the Fuser itself.

7. Now you should see the image from the Main PC on your Main Monitor.

If this doesn't happen, press the CH button on the remote control (and the Fusion button again if necessary).

8. If you notice any visual artifacts on the Main Monitor, slightly reduce the refresh rate. For example, lower it from 144 Hz to 120 Hz.

resolution and refresh rate godlike dp fuser 10

Both of your monitors should be set to the same resolution.

The refresh rates can be different — for example, the Main Monitor may run at 144 Hz while the Second Monitor runs at 60 Hz, or vice versa.

However, this may make the overlay appear less smooth. If possible, use the same refresh rate on both monitors for the best experience.

9. If you notice visual artifacts like these on your Main Monitor, press the TR+ or TR− button on the remote control until they disappear.

10. Your Fuser is now fully set up and ready to use. After launching the game and your DMA cheat, press the Fusion button on the remote control to display the cheat overlay on your Main Monitor.

Video Manual

Main Monitor doesn't work

If the main PC just shows a black screen and shows no signs of life, make sure that:

You have connected the DisplayPort and HDMI cables correctly
No other DP or HDMI cables are connected to the main monitor
The Fuser is plugged into an outlet and turned on using the red button
You selected the resolution and refresh rate supported by Fuser on the Second Monitor and pressed the button with the corresponding parameters on the Fuser remote control

If none of the above helped. Disconnect all cables and start following the instructions from the beginning

Monitors aren't working properly

If an image with an incorrect resolution or refresh rate is displayed on the main monitor, make sure that:

You're using the resolution and refresh rate supported by Fuser and have set it to me on both monitors
In the section Display settings on the Second PC you selected Duplicate these displays

No supported resolution

If Fuser doesn't support your resolution or screen refresh rate, then lower them to the closest values that are supported.

For example, if your monitor specs are 4K120hz, downgrade to 4K60hz or 2K120hz.

Remote doesn't work

Remote control doesn't work

Make sure you installed 2 AAA batteries into the remote control.

Where to download?

You can download DMA Cheats folder here — https://www.dma-cheats.com/download

tools, drivers for dma card, firmware, kmbox, fuser, dma cheats, xim matrix, ferrum

See all Products →